Extron electronics DTP2 R 211, Руководство пользователя, Страница: 26 / 43

DTP2 T/R 211 • Installation and Operation 18
• Select
Yes, now and every time I connect a device
(see figure 11 ,
2
on the
previous page) if you want the computer to automatically connect to Windows
Update to search the web every time the transmitter or receiver is connected to this
USB port.
• Select
No, not this time
(
3
) if you do not want the computer to connect to
Windows Update to search the web at this time (for example, if the driver is already
on your computer).
3. Click
Next
(
4
).
The next screen of the Wizard opens:
1 1
2 2
Figure 12. Installing the Software Automatically
4.
Select
Install the software automatically (Recommended)
radio button (see
figure 12,
1
above).
5. Click
Next
(
2
).
NOTE: You do not need to insert an installation disc.
The PC locates the driver needed and installs it in the correct location on the hard drive.
6. When the
Completed
screen appears, click
Finish
to close the wizard.
NOTE: The wizard opens only on the first occasion you connect the transmitter
or receiver to that USB port. The wizard reappears if you connect the unit to a
different USB port or if you connect a different piece of equipment, requiring a
different driver, to the same USB port.
7. Configure the transmitter or receiver as required using SIS Commands (see Remote
Control starting on page 20).
Resetting
Use the SIS command to reset the transmitter or receiver to its factory default settings (see
Reset on page 23).
12