Extron electronics Dtp t/r dp 230, Руководство пользователя, Страница: 11 / 18

DTP DP 330 and DTP DP 230 Twisted Pair Extenders • Installation and Operation 5
E
TP Output RJ-45 connector — Connect one end of a TP cable to this
SIG LINK
OUT
RJ-45 female connector on the transmitter. Ensure the opposite end of this
cable is connected to the receiver TP Input RJ-45 connector (see item
G
,
below).
ATTENTION:
• Do not connect these devices to a telecommunications or computer data
network.
• Ne connectez pas ces appareils à des données informatiques ou à un réseau
de télécommunications.
NOTE:
See TP cable termination and recommendations on page 7 to properly
wire the RJ-45 connectors and for detailed NOTES .
Signal LED — Indicates the unit is receiving a DisplayPort signal on the DisplayPort
input.
Link LED — Indicates a valid link is established between the units on the DTP input
and output cable.
F
Power connector — Plug the included external 12 VDC power supply into either this
2-pole connector
or
the power input connector on the receiver (see
item
K
on page 6).
ATTENTION:
• Do not connect power to the DTP DP 330 or DTP DP 230 until you have read
the
CAUTION and ATTENTION notices on pages 8 and 9.
• Ne branchez pas l’alimentation au DTP DP 330 ou DTP DP 230 avant d’avoir lu
les deux rubriques «
ATTENTION » aux pages 8 et 9.
NOTE: When the TP function switch (see item
D
on page 4) is in the DTP
position , one power supply can power both units.
When the TP function switch is in the HDBT position , the transmitter
and receiver each requires a local 12 VDC power supply.
Receiver Connections
G
DTP Input RJ-45 connector
— Connect one end of the TP cable from
SIG LINK
DTP IN
the transmitter output connector to this RJ-45 female connector. Ensure the
opposite end of this cable is connected to the transmitter DTP Output RJ-45
connector (see item
E
, above).
ATTENTION:
•
Do not connect these devices to a telecommunications or computer data
network.
• Ne connectez pas ces appareils à des données informatiques ou à un réseau
de télécommunications.
NOTE: See TP cable termination and recommendations on page 7 to properly
wire the RJ-45 connectors and for detailed NOTES .
Signal LED
— Indicates the unit is receiving a valid signal on the DTP In connector.
Link LED — Indicates a valid link is established between the units on the DTP input
and output cable.