4
68-2762-50 Rev. B
5 17
© 2015 Extron Electronics — All rights reserved. All trademarks mentioned are the property of their respective owners.
www.extron.com
Step 7 — Final Installation
a.
Make all connections, power the units, and test the system for satisfactory operation.
b.
At the power outlet, unplug the power supply.
c.
Mount the extender into the wall box, and attach the supplied decorator-style faceplate to the unit.
d.
At the power outlet, reconnect the power supply. This powers up both units.
Operation
NOTE:
Input switching can be performed via auto switching, RS-232, or IR through the rear panel connectors.
After all devices are powered up, the system is fully operational.
Extender LEDs
A
LEDs
— These two-color front panel LEDs on the extenders light to indicate signal and power status as follows:
•
Amber
— The unit is receiving power but there is no signal on the associated input.
•
Green
— The unit is receiving power and a signal is present on the associated input.
B
Switch LED
— Lights green when auto switch is active.
C
LEDs
— Light green when an HDMI or DisplayPort input has been authenticated on the source device.
Audio Configuration
The DTP T DWP 4K D series can embed analog audio inputs onto the digital video output.
NOTE:
If no HDMI or DisplayPort signal is present, analog audio transmitted over the DTP connection to the analog audio
output of the receiver.
When an input is selected, audio transport over HDMI or DisplayPort can be configured to operate in one of three modes. Each
input can be configured individually for any of the three modes.
•
Transport digital embedded audio (default)
— The digital embedded audio content on the digital video input is transported.
Analog audio is still separate from the digital embedded audio on the HDMI or DisplayPort signal and transported
simultaneously over the DTP output, not embedded onto the digital output.
•
Embed analog audio input
— The analog audio input is always embedded to the digital output, replacing whatever content
is already present on the digital embedded audio. Analog audio is also transported over the DTP output as a simultaneous
output.
•
Auto select between analog audio and digital embedded audio
— When both analog audio and digital embedded audio
on HDMI or DisplayPort are present, digital embedded audio on the HDMI or DisplayPort signal takes priority. Analog audio is
transported simultaneously with the digital embedded audio content that is already present on the DTP output.
AUDIO IN
AUTO SW
HDCP
1
2
CONFIG
HDMI IN
AUDIO IN
DP IN
Extron
A
A
B
C
DTP T DWP 4K D Front Panel
