DTP HDMI 4K D Series Transmitter and Receiver • Installation and Operation
11
Power Supply Wiring
NOTES:
•
Only one power supply is required. A single power supply connected to either unit
in the pair powers both units.
•
A power supply is included with each individually-packaged transmitter.
•
Do not tin the power supply leads before installing them in the direct insertion
connector. Tinned wires are not as secure in the connectors and could be pulled
out.
Figure 10 shows how to wire the power connector. Snap the provided ferrite bead onto the
DC power cable, between the power supply and the connector on the HDMI unit.
SECTION A–A
A
A
Power Supply
Output Cord
Captive Screw
Connector
Ridges
Smooth
3/16"
(5 mm) Max.
Figure 10.
Power Connector Wiring
CAUTION:
The wires must be kept separate while the power supply is plugged in.
Remove power before wiring.
ATTENTION :
Les deux cordons d’alimentation doivent être tenus à l’écart l’un de
l’autre quand l’alimentation est branchée. Couper l’alimentation avant de faire
l’installation électrique.
