
Extron DTP HD DA 4K Series • SIS Configuration and Control
10
SIS Configurations
and Control
Use SIS commands to configure the DTP HD DA 4K series. This section provides
information about using those commands. Topics include:
•
•
Using the Command and Response Table
•
Command and Response Table for SIS Commands
Introduction to SIS
The distribution amplifiers can be set up and controlled remotely via Extron SIS commands
that are issued from a host computer running the Extron DataViewer utility or other control
system. The host device can be connected to the mini USB config port on the front panel,
the RJ-45 LAN connector on the rear panel, or the the 3-pole RS-232 captive screw
connector on the rear panel. The protocol for the Remote serial port is as follows:
•
9600 baud
•
8 data bit
•
no parity
NOTE:
The wiring in the RS-232 cables crosses over so that the distribution amplifier
transmit (Tx) wire connects with the control device receive (Rx) and vice versa.
Host-to-Distribution Amplifer Communications
SIS commands consist of strings (one or more characters per command field). No special
characters are required to begin or end a command sequence. Unless otherwise stated,
upper and lower case characters can be used interchangeably. Most responses from the
distribution amplifier end with a carriage return and a line feed (CR/LF =
]
), which signal
the end of the response character string. When the switcher determines that a command is
valid, it executes the command and sends a response to the host device.
Distribution Amplifier-Initiated Messages
When a local event such as a change in signal status takes place, the distribution amplifier
responds by sending a message to the host, indicating the status change. No response is
required from the host.
Copyright Information
The copyright message is displayed upon connecting to a DA via TCP/IP or Telnet or after a
power cycle via RS-232. An example is provided below.
]
(©) Copyright 20yy, Extron Electronics, DTP HD DA8 4K 330, V
x.xx
,
60-
xxxx
-01
]
Mon, 6 Feb 2017 11:27:33
]
20yy
is the year the currently installed firmware was released,
V
x.xx
is the firmware version
Introduction to SIS
Содержание DTP HD DA 4K Series
Страница 1: ...User Guide DTP HD DA 4K Series Video Products DTP HDMI Distribution Amplifier 68 2545 01 Rev G 03 22 ...
Страница 2: ...Safety Instructions ...
Страница 6: ......
Страница 8: ...Extron DTP HD DA 4K Series Contents viii ...