Extron electronics DTP CrossPoint 108 4K, Руководство по установке

Страница: 39 / 44

31 DTP CrossPoint 4K Series • Remote Control
Starting the DSP Configurator Program
The DSP Configurator can connect to the switcher via any rear
panel LAN port or the front panel Configuration port.
NOTE: Extron recommends connection via an Ethernet LAN
port for the DSP Configurator program.
Start the DSP Configurator program, as follows:
1.
Click
Start > Programs > Extron Electronics > DSP
Configurator > DSP Configurator
. The DSP Configurator
Startup screen opens (see figure 22).
Figure 22. DSP Configurator Screen and Device Selection
TIP: You can also launch the DSP Configurator program
from within the Product Configuration Software.
2. Select the DTP CrossPoint switcher in the drop-down menu
and click
OK
.
TIP: If you have only DTP CrossPoint switchers of the
same model, click
Always perform the selected action
to
eliminate step 2 in future startups.
The DSP Configurator program starts in Emulate mode (see
figure 23 on page 32).
NOTE: In Emulate mode, changes and settings are stored
in the PC and not sent to the switcher until you select Live
mode and "push" the settings to the switcher. See the
DTP CrossPoint 4K Series User Guide .
20