Extron Headquarters
+800.633.9876 Inside USA/Canada Only
Extron USA - West
Extron USA - East
+1.714.491.1500 +1.919.850.1000
+1.714.491.1517 FAX
+1.919.850.1001 FAX
Extron Europe
+800.3987.6673
Inside Europe Only
+31.33.453.4040
+31.33.453.4050 FAX
Extron Asia
+65.6383.4400
+65.6383.4664 FAX
Extron Japan
+81.3.3511.7655
+81.3.3511.7656 FAX
Extron China
+86.21.3760.1568
+86.21.3760.1566 FAX
Extron Middle East
+971.4.299.1800
+971.4.299.1880 FAX
Extron Australia
+61.8.8113.6800
+61.8.8351.2511 FAX
Extron India
1800.3070.3777
(Inside India Only)
+91.80.3055.3777
+91.80.3055.3737 FAX
©
2017 Extron Electronics All rights reserved. All trademarks mentioned are the property of their respective owners.
www.extron.com
Configure Dante Device Settings (AT Models Only):
Dante settings on DMP 128 Plus AT models can be configured from DSP Configurator. The Dante device can be named here,
which aids in device identification in the Dante Controller software when there are multiple Dante devices on the audio network.
ATTENTION:
It is essential that a Dante device be named before audio subscriptions with other devices are
established. Existing subscriptions are removed when a device is renamed.
To configure Dante device settings:
1.
Open DSP Configurator and connect Live to the DMP 128 Plus AT (see step 3b on the previous page).
2.
Select
Tools>Device Settings
. The
Device Settings
dialog box opens.
3.
From the tabs at the top of the
Device Settings
dialog box, select
Dante
Device
.
a.
It may be necessary to use the right navigation arrow (
) at the top right
corner of the
Device Settings
dialog box to navigate to the
Dante
Device
tab (see figure to the right).
4.
In the
Device name
field, give the DMP 128 Plus AT a meaningful name
(such as device model and location) so that it can be easily identified in
Dante Controller.
5.
Dante device network settings can also be configured from this dialog box.
Use the radio buttons and text fields to choose
DHCP
(recommended) or
Static IP
and enter a static IP address configuration.
NOTE:
The device name and IP configuration in the
Dante Device
tab
only affect the Dante interface of the DMP 128 Plus AT. These settings
do not affect the device name recognized in DSP Configurator or the IP
address of the rear panel LAN port.
6.
Select
Enable Redundant Mode
only if configuring the DMP 128 Plus AT
for use on redundant networks. A separate set of redundancy network settings opens for configuration (see
Physical Dante
Network Setup
in the
DMP 128 Plus User Guide
for more information on redundant configuration).
7.
Click
Apply
.
8.
Click
OK
to confirm changes and close the
Device Settings
dialog box.
For more information on configuring a DMP 128 Plus AT model in Dante Controller, refer to the
Dante Controller
section of the
DMP 128 Plus User Guide
(
www.extron.com
).
68-2826-50 Rev. C
07 17
