3
Connection
CL
AS
S 1
LA
SE
R P
RO
DU
CT
5VD
C
1
2
STA
TUS
CLA
SS 1
LAS
ER P
RO
DUC
T
5VD
C
2
1
STA
TUS
Hi-resolution Display
with DVI-D Input
PC with DVI-D Output
Multi Mode Fiber
(2)
Up to 500 m
(1,640’)
DDX 102 Tx
DDX 102 Rx
1.
Ensure that the source device is off, connect the transmitter to the DVI output of the source, and tighten the thumbscrews.
2.
Ensure that the display device is on, connect the receiver to the DVI input of the display, and tighten the thumbscrews.
3.
Using two LC fiber optic cables, connect port 1 of the transmitter to port 1 of the receiver and connect port 2 to port 2 as
shown in the image below at the right.
NOTE:
If Single Link DVI is used, only fiber line 1 needs to be connected.
4.
Using two LC fiber optic cables, connect port 1 of the transmitter to port 1 of
the receiver and connect port 2 to port 2 as shown in the image at right.
NOTE:
If Single Link DVI is used, only fiber ine 1 needs to be
connected.
5.
Connect the 5V power adapters to the transmitter and the receiver. The
Power LEDs turn on.
NOTE:
The power adapter does not need to be connected to the
transmitter if the graphic source provides enough power to operate
the transmitter.
6.
Turn on the source device and ensure that the Status LEDs on the
transmitter and receiver are on.
CLASS 1 LASER PRODUCT
5VDC
1 2
STATUS
CLASS 1 LASER PRODUCT
5VDC
2 1
STATUS
Fiber Line 2
Fiber Line 1
Troubleshooting
The display does not show an image
•
Ensure that all plugs and jacks used by external power supplies are firmly connected.
•
Ensure that the Power and Status LEDs for both the transmitter and receiver are lit.
•
Ensure that the DVI ports are firmly plugged into the computer and display.
•
Ensure that the transmitter and receiver are plugged properly to the computer and display.
•
Ensure that the fiber optic cables are connecting the correct ports. Port 1 of the transmitter must be connected to port 1 of
the receiver. Port 2 of the transmitter must be connected to port 2 of the receiver.
•
Ensure that the source device and output device are powered on and have booted up correctly.
•
Ensure that the correct EDID information has been stored on the transmitter. When using the DDX 102 Tx/Rx for the first
time or if the display device is changed, it is essential to set up the EDID Minder
™
as described in steps 1 through 5 of
on page 2 of this guide.
•
Reset the system by unplugging and reconnecting the DVI connectors or the power jacks.
•
Reboot the computer.