DAK SF 26CT • Setup Guide (Continued)
© 2019 Extron Electronics — All rights reserved.
All trademarks mentioned are the property of their respective owners.
Worldwide Headquarters:
Extron USA West, 1025 E. Ball Road, Anaheim, CA 92805, 800.633.9876
For information on safety guidelines, regulatory compliances, EMI/EMF compatibility, accessibility, and related topics, see the
Extron Safety and Regulatory Compliance Guide
on the Extron website.
2
2.
Set the rotary tap selector switch
to the appropriate
setting using a small screwdriver (see figure 3).
ATTENTION:
•
When setting the taps for a distributed (high
impedance) system, do not tap the system
above the rated power of the amplifier.
•
Lors de la mise en place des capteurs pour
un système distribué (haute impédance),
n’exploitez pas le système au delà du
niveau d’alimentation de l’amplificateur.
•
When connecting multiple speakers in
8-ohm mode, be sure that the combined
rated impedance does not equal a value
less than the minimum rated impedance of
the amplifier.
•
Lors de la connexion de plusieurs enceintes
en mode 8 ohm, assurez vous que le
niveau d’impédance combinée ne soit
pas équivalent à une valeur inférieure à
l’impédance minimum de l’amplificateur.
3.
Install the grille
. Position the grille so that it covers the
baffle of the speaker (see figure 4). Six small magnets
secure the grille in place.
4.
Repeat all the steps above, for all speakers.
The completed speaker installation is now ready for use.
Test and adjust each speaker assembly as needed.
68-2223-52 Rev. A
02 19
Speaker Grille
8Ω
8Ω
64W
32W
OF
F
8W
16W
64W 32W 16W
OF
F
100 V
70
V
Adjust the Tap Selector
8Ω
8Ω
64W
32W
OF
F
8W
16W
64W 32W 16W
OF
F
100 V
70
V
8Ω
8Ω
64W
32W
OFF
8W
16W
64W
32W
16W
OFF
100
V
70
V
Figure 4.
Install the Grille
Figure 3.
Set the Rotary Tap Selector Switch
