background image

CS 3T • Setup Guide (Continued)

Extron Headquarters

+1.800.633.9876 (Inside USA/Canada Only)

Extron Asia

+65.6383.4400

Extron China

+86.21.3760.1568

Extron Korea

+82.2.3444.1571

Extron Europe

+31.33.453.4040

Extron Japan

+81.3.3511.7655

Extron Middle East

+971.4.299.1800

Extron India

+91.80.3055.3777

© 2014 Extron Electronics — All rights reserved.  All trademarks mentioned are the property of their respective owners. 

www.extron.com

68-2543-50 Rev.

 

11 14

4

12. 

Attach secondary support lines (open back configuration). 

Secondary 

Support Line

Secondary

Tie off Point

Zip Tie

Strain Relief

Tab

13. 

Replace the adjacent tile

 that was removed in 

step 3

 on page 1.

14. 

Set the rotary tap selector switch

  to the appropriate setting, using a small screwdriver. 

 

Adjust the Tap Selector

8W

16W

100 

V

70 

V

4W

2W

4W

2W

1W

8W

8Ω

16W

15. 

Install the grille.

  Position the outer perimeter of the grille into the groove of the speaker baffle. Six magnets pull the grille 

securely into place. 
 

Speaker Grille

NOTE:

  Grille hooks are provided for removal of the grille after installation.

ATTENTION:

 

• 

Do not

 allow any slack in the secondary support line.

• 

Ne laissez aucun jeu au niveau du filin de sécurité 
secondaire.

Содержание CS 3T

Страница 1: ...cribed below a Remove the ceiling tile and draw diagonal lines across the non visible side from opposite corners to locate its center Mark the intersection where the lines cross b Position the center hole of the cutout template directly over the center of the tile marked in step a c Trace a circle on the ceiling tile as follows For installations in ceilings that are NOT fiberglass or when installi...

Страница 2: ... a chain of speakers is wired this way disconnecting one speaker does not remove power from the remaining speakers in the chain Wiring a Single Speaker Wiring Multiple Speakers Using Loop through When a chain of speakers is wired this way disconnecting one speaker removes power from all downstream speakers Speaker 1 Speaker 2 IN LOOP IN LOOP IN LOOP IN LOOP Black Red Red Red Black Black Power Ampl...

Страница 3: ...ghten the zip tie Figure 1 Figure 2 Figure 3 Secondary Tie off Point Zip Tie 11 Mount the CS 3T a Insert the CS 3T through the bottom of the hole in the ceiling tile that was cut in step 2 on page 1 b Tighten the four screws clockwise until the speaker is securely clamped to the ceiling Mounting the Speaker with the CS 120P Mounting the Speaker without the CS 120P c If using the CS 120P proceed to...

Страница 4: ...ck configuration Secondary Support Line Secondary Tie off Point Tie Strain Relief Tab 13 Replace the adjacent tile that was removed in step 3 on page 1 14 Set the rotary tap selector switch to the appropriate setting using a small screwdriver Adjust the Tap Selector 8W 16W 1 0 0 V 7 0 V 4W 2W 4W 2W 1W 8W 8Ω 8Ω 16W 15 Install the grille Position the outer perimeter of the grille into the groove of ...

Отзывы: