Extron electronics Cable Cubby 1202, Руководство по установке

Страница: 4 / 8

4
Cable Cubby 1202 and 1402 • Installation Guide (Continued)
Option 2: Cable Pass-Through Module
Option 3: Retractor Bracket
Use the Retractor Bracket to mount Retractors in the Cable Cubby enclosure. There are two options for installing the bracket
(Options 3a and 3b, below).
NOTE: If installing more than one bracket in the Cable Cubby 1402, see Retractor Configuration for
Cable Cubby 140
2 on page 7.
NOTE: After assembling the module, proceed to Step 2 — Install the Modules on the next page.
NOTES:
•
After installing the bracket, proceed to
Step 2 — Install the Modules
on the next page to install the power module.
•
After mounting the Cable Cubby on the table, install the Retractors (see Installing Retractors on page 7).
Option 3a
Use this option for the Cable Cubby 1202, and for vertical
or angular Retractor mounting in a Cable Cubby 1402.
Option 3b
Use this option for horizontal Retractor mounting in a
Cable Cubby 1402 only.
Secure the grommet plate on
the connectivity bracket
using four of the provided
module screws.
Insert cables through
the bottom of the connectivity
bracket and into the holes of
the grommet plate.
Snap the included
hole plugs into any
unused holes.
3
2
1
Insert the bracket as shown.
The bracket may be
installed on the left or right
side of the enclosure and
must be installed at the lowest
height.
1
Secure the bracket using four
of the provided pan-head
mounting screws with star
washers. Tighten the screws
using a screwdriver.
2
Insert the bracket as shown.
The bracket may be
installed on the left or right
side of the enclosure and must
be installed at the lowest height.
1
Secure the bracket using four of
the provided pan-head mounting
screws with star washers. Tighten
the screws using a screwdriver.
2