3
Step 2 - Install Connectivity Bracket and the MAAPs
Follow the steps below to populate the Cable Cubby enclosure.
Step 2a — Assemble and Install the Connectivity Bracket
Follow the steps below to assemble and install the connectivity bracket with the included cable grommet plate or optional
two-space MAAP module.
1
1
2
2
2
3
Insert cables into
the holes of the
grommet plate.
Use the #4-40 plate screws
to secure the grommet plate
on the connectivity bracket.
Snap the included hole
plugs into any unused
holes.
Insert the assembled module
into the bottom opening of the
enclosure.
Secure the module at the desired
height using the included #6-32
bracket screws.
Use the included #4-40 MAAP screws
to secure the two-space MAAP on the
enclosure.
US
B C
HA
RG
ER
1
Insert wires through
the opening shown
at the right and
wire the MAAP.
NOTE:
Using the cap screws that
are not included with the MAAP
may not allow the bezel to fit
properly.
1
1
2
2
2
3
Insert cables into
the holes of the
grommet plate.
Use the #4-40 plate screws
to secure the grommet plate
on the connectivity bracket.
Snap the included hole
plugs into any unused
holes.
Insert the assembled module
into the front opening of the
enclosure.
Secure the module at the desired
height using the included #6-32
bracket screws.
Use the included #4-40 MAAP screws
to secure the two-space MAAP on the
enclosure.
US
B C
HA
RG
ER
1
Insert wires through
the opening shown
at the right and
wire the MAAP.
2
S
h
b
NOTE:
Using the cap screws that
are included with the MAAP may
1
1
2
2
2
3
Insert cables into
the holes of the
grommet plate.
Use the #4-40 plate screws
to secure the grommet plate
on the connectivity bracket.
Snap the included hole
plugs into any unused
holes.
Insert the assembled module
into the bottom opening of the
enclosure.
Secure the module at the desired
height using the included #6-32
bracket screws.
Use the included #4-40 MAAP screws
to secure the two-space MAAP on the
enclosure.
US
B C
HA
RG
ER
1
Insert wires through
the opening shown
at the right and
wire the MAAP.
NOTE:
Using the cap screws that
are not included with the MAAP
may not allow the bezel to fit
properly.
Step 2b — Install the MAAP plate(s) on the MAAP Opening on
applicable models
Follow the steps at the right to install a double-space
MAAP or two single-space MAAPs of your choice
(see
www.extron.com
for MAAP options and wiring
instructions). Install the MAAP in the MAAP opening as
shown at right.
To assemble the Cable Grommet Plate (included):
To assemble an optional MAAP module:
1
2
Wire the MAAP.
Use the #4-40 cap screws (included
with the MAAP) to secure the MAAP
on the connectivity bracket.
US
B C
HA
RG
ER
