2
68-3473-50 Rev. A
10 19
© 2019 Extron Electronics — All rights reserved.
All trademarks mentioned are the property of their respective owners.
Worldwide Headquarters:
Extron USA West, 1025 E. Ball Road, Anaheim, CA 92805, 800.633.9876
For information on safety guidelines, regulatory compliances, EMI/EMF compatibility,
accessibility, and related topics, see the
Extron Safety and Regulatory Compliance
on the Extron website.
Mounting the Lid Insert into the Lid Tray
NOTES:
•
Test fit the lid insert before securing it in the lid tray.
•
The top of the surface material insert should be flush with the top of the lid tray. Shims or putty may be necessary to
level and flush the surface material.
Option 1b: Mount the fabricated lid without
screws
Secure the lid onto the Cable Cubby
using the proper adhesive or putty.
4
Place the lid insert in the tray and ensure a
proper fit. If necessary, carefully trim the
lid insert.
If using screws, perform
2
and
3
.
If NOT using screws, perform
4
.
Option 1a: Mount lid insert with screw
Mark and drill four 3/32-inch pilot
holes, 3/8 inch deep.
Secure the lid insert into the lid tray
using four #6 flat head wood screws.
1
2
3
Completing the Installation
1.
Align the lid tray to the Cable Cubby. The back edge of the lid lines up with the back of the Cable Cubby lid mechanism.
2.
Secure the lid tray onto the Cable Cubby using the provided #4 flat head lid tray screws.
3.
See the
Cable Cubby 1252 MS Installation Guide
to complete the Cable Cubby assembly and mount the Cable Cubby in the
table.
Extr
on
