3
Assembly
Handle Installation
NOTE: Assemble the handle first
to make it easier to move the tool
cabinet.
Simply position the handle over the
holes in the cabinet and attach with
the provided M6 x 12 hex bolts.
Tighten securely.
Repeat for the other cabinet handle
on the other side of the cabinet.
Operation
Drawer Removal
Pull the drawer out so that it’s
almost fully extended. Push up on
the black release lever on one side,
while pulling down on the black
release lever on the other side.
While holding the levers in the
positions as instructed above,
pull the drawer outward until it is
released from the drawer slide.
Drawer Replacement
Extend the drawer slides. Insert
the brackets on each side of the
drawer into the slots in the slides,
being careful that they are properly
positioned. Once properly inserted,
completely close the drawer to set
the slides in their proper positions.
Push up (one side)
Push down (other side)
Maintenance
Lubricate the casters once a year with high quality bearing grease.
Lubricate the slides twice a year with a product like WD40 or other quality
lubricant. This is especially necessary as the temperature decreases, which can
cause the bearing to become stiff.
Periodically clean the drawer fronts, drawer trim and other surfaces with mild
detergent and water.
Grease and oil can be removed with most standard cleaning fluids. For safety,
use a nonflammable cleaning fluid.
