Fiber Optic Ports and Optical Safety
Summit X460-G2 Series Switches Installation Note
7
Fiber Optic Ports and Optical Safety
The following safety warnings apply to all optical devices used in Extreme Networks equipment that
are removable or directly installed in an I/O module or chassis system. Such devices include but are not
limited to gigabit interface converters (GBICs), small form factor pluggable (SFP) modules (or
mini-GBICs), QSFP+ modules, XENPAK transceivers, and XFP laser optic modules.
WARNING!
Laser optic modules become very hot after prolonged use. Take care when removing a laser optic module
from the module or option card. If the laser optic module is too hot to touch, disengage the laser optic module and
allow it to cool before removing it completely.
WARNING!
When working with laser optic modules, always take the precautions listed below to avoid exposure to
hazardous radiation.
●
Never look at the transmit LED/laser through a magnifying device while the transmit LED is
powered on.
●
Never look directly at a fiber port on the switch or at the ends of a fiber cable when they are
powered on.
●
Invisible laser radiation can occur when the connectors are open. Avoid direct eye exposure to the
beam when optical connections are unplugged.
●
Never alter, modify, or change an optical device in any way other than suggested in this
document.
GBIC, SFP (Mini-GBIC), QSFP+, XENPAK, and XFP Regulatory
Compliance
Extreme Networks pluggable optical modules and direct-attach cables meet the following regulatory
requirements:
●
Class 1 or Class 1M Laser Product
●
EN60825-1:2007 2nd Ed. or later, European standard
●
FCC 21 CFR Chapter 1, Subchapter J in accordance with FDA & CDRH requirements
●
Application of CE Mark in accordance with 2004/108/EEC EMC Directive and the 2006/95/EC Low
Voltage Directives
●
UL and/or CSA registered component for North America
●
47 CFR Part 15, Class A when installed into Extreme products
