1 Adjust the length of the two assemblies (callout 1) to agree with the distance between the outer face
of the vertical rack posts.
The screws (callout 5) holding the assembly together may need to be loosened slightly to allow for
the adjustment. Retighten any loosened screws after the adjustment has been made.
2 Install the side of the assembly labeled "right front" (callout 2) on the front (cool air inlet) right rack
post.
Secure the assembly to both the front and rear posts, using rack appropriate screws or fasteners
that you supply.
Do not use the middle hole when securing the assembly to the rack post. The middle hole is used to
secure the adapter plate (previously installed on the chassis) to the assembly.
3 Repeat step
for the assembly labeled "left front."
Installing the Chassis to the Rail Assembly
Refer to
as you perform the following procedure.
Figure 26: Installing the Chassis on to the Rack Mount Rail Assembly
1 = Rack front (cool air inlet)
5 = Rail assembly middle screw hole
2 = Rack specific screw (2)
6 = Rail assembly flange
3 = Chassis air intake side
7 = Rear rack post
4 = Adapter plate ear
8 = Rail assembly to rack screws
To install the chassis into the rail assembly, follow these steps:
1 Face the front (cool air) side of the rack (callout 1) with the air intake side of the chassis (callout 2)
facing you.
2 Slide the chassis with the installed adapter plates onto the rack mount rails until the adapter plate
ear (callout 3) meets the middle screw hole (callout 4) of the rack mount rail.
Optional Rack Mount Rail Kit Installation
S-Series Stand Alone (SSA) Switch Hardware Installation Guide
58
