6 Attach the pole bracket to a pole by positioning the cable clamps around a pole.
7 Insert the ends of the cable clamps around the pole and tighten the clamp screws to a torque of 11
in-lbs.
Attaching the access point to a pole using the WS-MBO-POLE01 bracket and
MBO-ART02 articulating mounting bracket
The following hardware is required to install the access point to a pole using the WS-MBO-POLE01
bracket and the MBO-ART02 bracket.
•
WS-MBO-POLE01 bracket
•
MBO-ART02 bracket
•
Two M6 hex-head screws
•
Four M3 screws, nuts, and washers to attach the WS-MBO-POLE01 bracket to the MBO-ART02
articulating mounting bracket
•
Two cable clamps
Note
You need to provide your own stainless-steel cable clamps. The band must be 1/2” (12.7
mm) wide.
•
Access point
To mount the access point on to a pole using WS-MBO-POLE01 bracket and the MBO-ART02
articulating mounting bracket:
1 Attach the MBO-ART02 articulating mounting bracket to the access point using two M6 hex-head
screws.
Install the Access Point
ExtremeMobility AP460i/e Outdoor Access Points
27
