- 2 -
PACKAGE CONTENTS
CHARGING THE BATTERY PACK
TO TURN ON
VEHICLE BATTERY INSTALLATION
PREPARING THE REMOTE CONTROLLER
A/C Adapter
Extra Set
Race Tires
Remote Control
Drift Car
1. Remove the bottom of the remote controller by sliding in direction of arrow.
2. Remove the bottom cover of the remote controller and install fresh 8 x ‘AA’ Batteries (Alkaline recommended) into the bottom of
the remote. (Figure 1)
3. Replace the bottom cover.
4. Extend antenna into upright position on remote controller.
5. To charge rechargeable batteries, plug charger into AC port on back side of controller.
TRANSMITTER BATTERY INSTALLATION:
Slide open battery cover in the direction
of the arrow
Insert batteries making sure to follow
the designated (+) and (-) signs
Close the battery compartment
Figure 1
RECHARGING: WARNING!
USE UNDER THE DIRECT SUPERVISION OF AN ADULT.
* The newly purchased Ni-cd pack is not charged.
Charge before operating.
1. Connect the A/C Charger to the connector of the Ni-CD battery pack. Clip into place.
2. Plug the A/C charger into an 110V power outlet.
3. Recharge for up to 4 hours.
4. When the recharging is over, unplug the charger from the electrical outlet, then detach the connectors.
Store for safe-keeping
1. First turn car to ON (ON/OFF switch located on bottom of car). Lights on car will activate.
2. Turn Remote Controller to ON with indicators on remote set to NORM.
12V High Performance
Battery - Pack
12V HIGH PERFORMANCE
BATTERY - PACK
110V power outlet.
Charger
Battery’s Connector
Charger’s Connector
BATTERY CHARACTERISTICS AND RECHARGING TIPS
The battery power may be weak when operating car for the first time or after a long
interval without use. Continue to use and charge the vehicle.
The battery will gradually strengthen after 2 or 3 repetitions of usage and recharging.
Do not charge the battery pack immediately after use! Wait until battery pack has
completely cooled before charging.
1. Unlatch lever of the battery cover and slide open.
2. Insert battery pack by lining up connectors and clip into place.
3. Replace the battery cover. Slide lever back into place and reinstall the screw.
• Correctly charging battery pack will avoid short circuits. Short circuits
will cause overheating, burning of the cords and other damage to the
battery pack and charger.
• The Ni-CD battery charger should be used for charging one battery pack.
Do not use the charger for charging other types of batteries and battery packs.
• Do not use charger as a direct current outlet for other electrical
appliances or machines.
• Make sure that the battery pack and charger are kept out of the hands
of infants and small children at all times. Do not charge near fires,
locations where the temperature is extremely high. Keep water away
from battery pack, especially while charging.
• The battery and charger will slightly heat up while charging. Keep area
free of obstacles while charging.
• If the power of the battery pack is weak in spite of proper charging, the batteries
may be worn out from repeated use. Replace it with a new Ni-CD battery pack.
• Disconnect the A/C Charger before making or breaking connections to the battery.
• Only use recommended battery pack.
• WARNING! DO NOT ATTEMPT TO RECHARGE NON-RECHARGABLE
BATTERIES IN CONTROLLER.
• Use enclosed battery charger for the rechargeable battery pack only.
• The charger is not intended for use by children under 12 years old. Charge under
direct adult supervision.
• Inspect the charger on a consistent basis, especially the leads and connectors.
Do not use if there are signs of damage.
• Never attempt to dismantle or repair the charger. Only use as a Ni-CD battery charger.
Not suitable as a main adaptor or transformer.
• Never attempt to recharge non-rechargeable batteries – this could result in damage
to battery and charger.
• Do not overcharge your battery pack. This will not increase running time and will
cause damage to your battery and charger.
• Do not charge near water.
SPECIAL PRECAUTIONS
• Store and operate this product away from excessive heat and moisture.
• Charge battery pack indoors only.
• Dispose of used Ni-CD battery packs correctly. Waste Electrical Products should not
be disposed of with household waste. Recycle where facilities exist.
• Never dispose of into a fire.
