Figure 34: Wall-Mount: Attaching 5320-16P models to a wall
There is a "cleaner" method of attaching the mounting ears to the switch so that they are tucked under
the switch instead of pointing away from the switch.
illustrates attaching the mounting ears
so that they are underneath the switch.
Figure 35: Alternate method of attaching mounting ears to 5320-16P models
Mount the Device Under a Table (5320-16P models)
The 5320-16P switch models are constructed so that they can be mounted under a table. Ensure that
the table is strong enough to support the weight of the switch and the attached cables.
To mount a switch under the table, follow these steps.
1. Using the two holes in each short mounting ear, mark the places under the table to mount the
switch. Each mounting ear has two mounting holes, so be sure to make four marks.
2. Drill a hole at each mark.
3. Insert a provided anchor into each hole, if an anchor is needed. Gently tap each anchor with a
hammer, if necessary, to ensure that it is inserted tightly.
4. Using rack mount screws, attach a mounting ear to the left side of the switch, at the front end.
shows the attachment of the screws.
5. Repeat step
for the right side of the switch.
6. Mount the switch under the table by screwing a provided wood screw through each hole in the
mounting ears into the anchors. Ensure that all screws are securely fastened and that the switch is
firmly attached to under the table.
Install Your Switch
Mount the Device Under a Table (5320-16P models)
ExtremeSwitching 5320 Series Hardware Installation Guide
59
