9
Center your servo using your
radio. Place a servo arm on the
servo so that at center it sticks
out of the hole at right angles to
the servo mount door.
Run the servo wire through the
wing and screw into place.
1 inch/25mm arm is ideal for
ailerons. 3/4 inch / 20mm arm
for flaps is ideal.
Remove the servo mount/door,
and put a drop of thin CA into the
screw holes. Allow a few seconds
to cure and then screw back into
place.
Repeat for the other servos in
the wing.
Locate
the
shorter
two
pushrods, and four of the ball
links. Thread the ball links onto
the pushrod. The length of the
pushrod should allow the servo
arm to be perpendicular to the
wing when the aileron is at
center.
Use the 2mm screw and nuts to
mount the pushrod.
The length of the pushrod for the
flaps, with the flap closed, should
have the servo at the end of its
travel toward the surface.
Note:
The servo arm should still
be straight out of the wing when
centered, then move to end of
travel to adjust the length of
pushrod.