2. Use a fresh bottle of thin CA with a fine glue tip when attaching the CA
hinges. This will ensure that the proper amount of CA wicks into the hinge
and surrounding balsa wood and creates a proper bond between the wood and
hinges.
3. Take the time to properly balance and trim your aircraft and set up rates
and exponential values. Your flying experience will be greatly enhanced by
doing this.
Items needed for completion
-Hobby knife with #11 blades
-Thin and Medium CA.
-Blue Loctite.
-Small flat head and Phillips head screw drivers.
-Standard and needle nose pliers.
-Metric balldriver or allen key set.
-4 sub micro metal geared servos. All flight testing was performed with Hitec HS-65MG
and HS-5065MG digital servos and we strongly recommend the use of either of these high
quality servos.
-Torque 2814T/820 Brushless Outrunner motor.
-Airboss Elite 45 Amp ESC.
-4S 2100-2350 mah LiPo battery.
-APC 12x6 E prop (NOT the slow fly version!).
-40 mm Extreme Flight spinner.
-2 18"-24" extensions for the elevator and rudder servos and 2 6"-8" extensions to go
between the receiver and the aileron servo leads. We recommend the 28 or 32 AWG
extensions to save weight.
3
