Extraflame 001282105, Руководство пользователя

Страница: 18 / 40

18 ENGLISH
Battery type and replacement
To insert/replace the batteries, simply remove the battery
protection cover at the back of the radio control device (figure 1).
Insert the batteries according to the symbols imprinted on the
radio control device and on the battery itself.
3 AAA batteries are required for the radio control device to
function.
cOnFIGUratIOn
RAdIo conTRol devIce codIng pRoceduRe:
1. disconnect the power supply to the stove.
2. press the keys
OK
and
OK
at the same time until the UNIT selection screen appears.
3. using keys
OK
and
OK
select the new UNIT '.
4. power the stove. Within 10 seconds (the led on the emergency module will flash) confirm the selected unit by pressing
OK
on the
radio control device.
5. The led on the emergency module will remain on for 5 seconds to confirm the new configuration.
6. If the configuration was not successful, "
" will appear on the display. In this case, repeat the procedure.
J
The radio conTrol device is already conFiGUred wiTh "UniT 0". iF There is anoTher sTove, To avoid
inTerFerences, a new conFiGUraTion MUsT Be PerForMed, ModiFyinG one oF The Two sToves.
soMe radio FreqUency devices (e.G. MoBile Phones, eTc.) May caUse inTerFerence wiTh coMMUnicaTion
BeTween The radio conTrol device and The sTove.
respect the environment!
used batteries contain metals that are harmful to the environment, and therefore must be disposed of separately in
special containers.
radIO cOntrOl devIce
(figure 1)
radIO cOntrOl devIce rOOm prOBe
calIBratIOn
This mode allows calibration of the room temperature detected by
the radio control device (with ventilation active only). For correct
calibration, it is recommended to position the radio control in a
room with constant temperature and wait for at least two hours.
Below find the calibration procedure:
Š
Access the menu and reach “ Tech MenU ”.
Š
Set the access key "F4". - " adJ reMoTe ProBe "
Š
using the keys
OK
or
OK
adjust the desired room
calibration.
Š
Save and exit with the key
OK
.