250mm
60mm
110mm
70mm
16mm
INSTRUCTIONS
AlvaLED GU10 Spike Light
–
240v
All finishes
WARNINGS
PLEASE READ THESE INSTRUCTIONS CAREFULLY PRIOR TO INSTALLATION / MAINTENANCE
•
If a fitting is found to be damaged, cease use immediately.
•
This is a Class 1 product and must be earthed.
•
This unit must be fitted by a competent person
–
if in doubt consult a qualified electrician.
•
Install in accordance with IEE wiring regulations and current Building Regulations.
•
To prevent electrocution, switch off mains supply before installing or maintaining this fitting. Ensure other persons
cannot restore the electrical supply without your knowledge.
•
This light fitting should be connected to a circuit with a 30Ma RCD fitted.
•
If replacing an existing fitting, make a careful note of the connections.
•
When changing the bulb, always switch off at the mains & allow the bulb to cool before handling
–
LAMP WILL GET HOT
WHEN IN USE
.
•
All connections should be made as watertight as possible to avoid electrical shortage.
•
Always use the correct type & wattage of bulb. Never exceed the wattage stated.
•
The unit may get warm whilst on for a period of time.
•
DO NOT INSTALL INTO THE GROUND BY PUSHING THE HEAD OF THE PRODUCT
SILICA GEL & O-RINGS (DO NOT REMOVE):
A small pack of silica gel has been included with this spike light, which is to be located inside the head with the bulb holder. This
should
not
be removed. Condensation inside the spike light is inevitable due to the heat generated from lamps and cold weather
conditions, especially if installed on a damp day. The pack of silica gel will collect the moisture inside the fitting, preventing this. It
is recommended that the silica gel is replaced when the light bulb is replaced, if not before, and the white rubber o-ring checked.
This fitting should not be used if there are any signs of damage.
CLEANING:
Occasional cleaning and care is recommended for this product. Please refer to our website for the best way to clean different
materials.
RETURNS & DISPOSAL:
If purchased from a 3
rd
party, please contact your supplier.
If purchased direct, contact us by phone or email:
Exterior Lights UK Ltd
,
P.O. Box 794, Orpington, Kent. BR6 1FB.
Tel: +44 1
689 606342
Our full returns policy is available on our website.
Waste Electrical Products should not be disposed of with household waste. Please check with your local authority or contact us
for more information. Please recycle packaging wherever possible.
Producer Registration Number: WEE/KC3440XY
Full product range & more information:
www.
exteriorlights.co.uk
Voltage:
220 - 240v 50Hz
Max Wattage:
20w
Bulb Holder:
GU10
IP Rating:
IP65
Cable Length:
3 core rubber cable 0.75mm (approx. 1m)
Head:
Adjustable
Materials:
Aluminium & Tempered Glass
Finishes:
Black (Powder Coated) / Titanium & Cocoa (Anodised)
Mount:
Spike Mount or Surface Mount
Additional accessories available
–
sold separately
✔✔✔
3 YEAR
GUARANTEE
see website for
more details
