25
SL355-en-GB_V1.8 8/17
11.8 OPTION Mode - Editing
Operation
Press
Display Shows
Comments
1. Select
Timer
Option
Continuing from Section 11.6
2. Switch
Timer
ON
The TIMER is now ON, therefore the
programmed Start and Stop times will
be used (unless Duration DUR settings
are enabled as shown in step 4
below).
3. Logging
Period
setting
LP allows the user to select a Logging
Period (data sample rate)
Press
to enable, use
and
to
select from the following Logging
periods: 1, 2, 5, 10, 15, 20, 30
seconds, 1, 2, 5, 10, 15, 20, 30, 60
minutes.
2 sec minimum for 8 hour Dose
4.
DURATION
setting
DUR allows the user to select a RUN
Duration time.
When a RUN duration period is shown
here, it takes precedence over the
Timer setting so that any preset start
and stop times WILL NOT BE USED.
Press
to enable and then use
and
to select from the following
durations: OFF, 5, 10, 15, 30 minutes,
1, 2, 4, 8, 10, 12, 24 hours; confirm
with
.
5. REPEAT
setting
Rept allows the user to select up to 49
repeats of the timer settings.
Press
to enable, use
and
to
select the number of repeats and then
confirm with
.