3
SDL700-EU-EN V1.4 03/12
Getting Started
Power ON-OFF
•
Power the meter by pressing and holding the power button for at least 1.5 seconds.
•
Press and hold the power button for at least 1.5 seconds to power OFF the meter.
•
This meter is powered by six (6) 1.5VDC ‘AA’ batteries or by optional AC adaptor. If the meter
will not switch ON please check that fresh batteries are installed in the rear battery compartment
or, in the case of the AC adaptor, check that the adaptor is connected correctly to the meter and
to an AC source.
Display Backlight
To turn the display backlight ON or OFF, press and hold the backlight
button for at least 1.5
seconds. The meter will beep when switching the backlight ON or OFF unless the beeper is
disabled.
Pressure Sensors
Pressure sensors are connected to the meter via the DIN jack at the top of the meter. Pressure
sensors of 2Bar (30psi), 10Bar (150psi) and 20Bar are available for use with the SDL700.
Note that re-calibration is not necessary when changing sensors; however the user must select the
appropriate sensor range in the Setup Mode. To view the currently selected sensor range from the
normal operation mode, press and hold the down arrow button
▼
for at least 1.5 seconds.
Units of Measure
The currently selected unit of measure is shown below the measurement value on the meter’s LCD.
To change the unit of measure, press and hold the UNIT button until the desired unit of measure
appears and then release the UNIT button. The meter begins scrolling through the available units of
measure (see table below) after the UNIT button has been depressed for at least 1.5 seconds.
UNIT DISPLAY
INDICATOR
psi
PSI
Inch Hg
In Hg
Inch H
2
O
In
H2O
hPA
hPA
kPA
_PA
Bar
bAr
Kg/cm
2
_g
C2
mm Hg
--Hg
Meters H
2
O
-t
H2O
Atmospheres
AtP
ZERO Adjustment
To null, or zero, the display for a connected sensor, press and hold the down arrow key
▼
for at
least 12 seconds.
Data Hold
To freeze a displayed reading on the LCD, momentarily press the HOLD button (the HOLD icon will
appear above the reading). To exit HOLD, press the HOLD button again.
netzerotools.com
netzerotools.com
