EN100
‐
150
‐
en
‐
US_v1.6
10/16
10
Select the preferred pressure units by pressing "REC" button unit the display shows
units. Press the Power button to change the units to HPA and then press “REC”
button to save. (mBar = hPa)
Select the Altitude function by pressing and holding the "HOLD" button until the
display indicates “
HigH
” and then release the HOLD button.
Press the HOLD button once, ‘hold’ will appear on the display. Press the REC button
for more than 3 seconds, the display will show either hpa, mmHg or inHg units.
Using the Power (up) or Hold (down) buttons, set the value to the known sea level
barometric pressure. Press the REC button to save the value.
Barometric Pressure Measurement
1.
Select the Barometric Pressure function by pressing and holding the "HOLD" button until the
display indicates “
bAr
” and then release the HOLD button.
2.
Select the pressure units by pressing "REC" button unit the display shows ‘units’. Press the
Power button to change the units and then press “REC” button to save. The available units are
hPA, mmHg, and inHg.
3.
The display will read the actual air pressure.
Note: Altitude and Air Pressure affect the actual Air pressure measurement.
4.
To view the Sea level Barometric pressure, follow this procedure
a.
Press the HOLD button once, ‘hold’ will appear on the display. Press the REC
button for more than 3 seconds, the display will show either Ft or m units.
b.
Using the Power (up) or Hold (down) buttons, set the value to the known actual
altitude value. Press the REC button to show the Sea level pressure.
Note: After powering OFF and then ON, the pressure reading will read actual
barometric pressure.
Temperature Measurement (Optional RTD probe)
1.
Plug the optional, (PT100) RTD probe into the "RTD Input Socket".
2.
Select the External Temperature function by pressing and holding the "HOLD" button until the
display indicates “
Pt
” and then release the HOLD button.
3.
Select the temperature units by pressing the "REC" button unit the display shows ‘units’. Press
the Power button to change the units and then press the “REC” button to save (°C or °F).
4.
Touch the RTD probe to the surface under test.
5.
The temperature value will display on the LCD display.
www.
.com
1.800.561.8187
