42512 V7.0 03/08
4
Operating Instructions
Temperature Measurements
1. Hold the meter by its handle and point it toward the surface to be measured.
2. Pull and hold the trigger to turn the meter on and begin testing. The temperature
reading, MAX temperature reading, the ‘SCAN’ icon, the emissivity value, and the unit
of measure will appear.
3. Release the Trigger and the reading will hold for approximately 7 seconds (HOLD will
appear on the LCD) after which the meter will automatically shut off. The only
exception to this is if the LOCK mode is set to ON.
Note
: Select the temperature units (ºF/ºC) using the switch inside the battery
compartment
Dual Laser Pointer
The dual laser pointers are designed to cross at a
distance of 30” (76cm). The spot size at this distance is
a 1” diameter and this is the recommended distance to
target for most measurements. To turn the lasers
on/off:
1. Press and release the Trigger
2. While HOLD is on the display, press the laser
button once to turn on the lasers on or off.
3. The laser icon will appear in the LCD when the
laser function is enabled.
4. The status of the laser will be stored in memory
and will remain as the “turn-on” condition until
changed.
