380460/380462-en-GB_v2.5 8/15
4
Powering the Meter
Connect the meter to the correct power source (110 or 220VAC); the Model 380460 uses 110VAC
and the Model 380462 uses 220VAC (note that these meters are NOT interchangeable). Do not
apply voltage to the meter input measurement terminals. Meter damage may result.
Measurement Procedure
1. Rotate the Range select switch to the desired range.
2. When using the 200m range, put the 200m select switch to the 200m position; for all other
measurement ranges put this switch in the opposite position
3. Perform a Zero Adjustment per the following:
Short the Kelvin Clips as shown in the diagram below.
(Make sure that the clips are clean)
Rotate the Zero Adjust Knob until the meter indicates zero units.
4. Either attach the test leads onto a component or attach the leads between two points on a
circuit.
5. Observe the meter reading.
