Gigabit PoE Injector with DIN-Rail Mounting Kit
2
DC-jack and 2-pin terminator blocks for power input:
To inject the
DC power to the Ethernet cable, the Injector needs a 12~24V DC
power applied either on its DC jack or the 2-pin terminal blocks
(but not both at the same time), its internal circuits will convert it to
56V DC to use for PoE.
Warning!!
Please make sure the polarity of the input power should be
correctly match the terminal block pins, otherwise it will damage
the Injector.
Power LED:
It Lights up when the 12~24V DC power is being
applied. It is OFF when no power is applied on DC jack or terminal
blocks.
LAN
Data input port: RJ45 connector for the data input. It accepts
10/100/1000Gbps Ethernet data cable.
PoE
output port: RJ45 connector that is able to be added 56V DC
power with the input Ethernet data. If there is a PoE PD was
connected, the Injector will supply the PoE power and lights up
the Amber LED. Otherwise, it won
’
t apply any power on the cable
and the Amber PoE LED will NOT light up.
1.
Connect data cable to RJ45 connector marked as
“
LAN
”
2.
Apply DC power (12~24V) to the DC jack or 2-pin Terminal Blocks
Connector. The Power LED should light up. If you are applying the
power on the 2-pin terminal blocks instead, please note its
polarity should match the marking next to the terminal blocks
’
pins.
3.
Connect your PoE PD device to the PoE port, the Amber PoE LED
should light up if the PD was detected and powered by the
Injector
3. Hardware Installation
+12~24V
GND
+
-
