DERR:
sets how the fixture responses if DMX-signal gets lost. Set
SAVE
to hold the last
received value or
BLAK
for blackout.
ZOOM:
in this menu the minimum position (
POS1
), maximum position (
POS2
) and the home position
(
BASE
) of the motorised zoom are set, when controlling the zoom manually. This settings are limited
by the zoom settings made in the menu
Zoom - Calibration
.
PERF:
gives the user the opportunity to change the performance of the fan between
LIVE
,
STDO
and
POWR
. In
STDO
mode the fan is run on low noise. In case of overheat the intensity of the led
module is regulated down. In
LIVE
mode, fan speed and the intensity of the led module is balanced
with each other to reach the best output with as low fan speed as possible. In
POWR
mode the
temperature of the fixture is primary regulated by the fan, to keep a high intensity as long as possible.
MCON:
sets if the fixture is a master and sends data to other fixtures (
MAST
), or not (
SELF
).
MENU
Zoom - Calibration
PERSON
CAL
HSIC
****
CALZ
HSIC
SEND
****
HSIC
0 - 255
POS1
HSIC
SEND
****
HSIC
0 - 255
POS2
In the calibration menu (
CAL
), submenu
CALZ
the general minimum (
POS1
) and maximum position
(
POS2
) of the motorised zoom can be set.
E-18
Current Software Version
When the software of the fixture is booting, the current installed software version is shown for about 5
seconds in the display.
