Explorer Patriot 430, Руководство по обслуживанию

Страница: 86 / 235

Use 60° cutter to cut a quarter lower parts out.
Remove the cutter and check new valve seat.
Use 45° cutter to grind the valve seat to
specified width.
Caution
Make sure that all roughness and uneven
faces had been ground.
Grind valve seat again if necessary.
Coat the valve seat surface with red paint.
Install the valve through valve guide until the
valve contacting with valve seat, slightly press
down the valve but do not rotate it so that a seal
track will be created on contact surface.
Caution
The contact surfaces of valve and valve seat
are very important to the valve sealing
capacity.
If the contact surface too high, grind the valve
seat with 32° cutter. Then, grind the valve seat
to specified width. If the contact surface too
low, grind the valve seat with 60° cutter. Then,
grind the valve seat to specified width.