Exploranium GR-135, Системное руководство, Страница: 50 / 80

SAIC Exploranium – GR-135 System Manual page: 50
b) WARMING UP
After the Startup screen is seen a new display appears as shown.
As specified in the display, the system is warming up so WAIT.
During this time the system is automatically adjusting its internal
parameters as well as charging the batteries
This basic process should take approximately 2 minutes but users are
recommended to leave it in the DS for approximately 1 hour before
starting any system operations to give the batteries time to take a
charge
Note that this “warm-up” mode only occurs when the unit is first put in use or if the unit has been
left out of the DS for an extended period of time (see section 10.2)
c) SYSTEM
READY
Once the system has AUTOMATICALLY adjusted the basic system
parameters correctly, the display shows :
SYSTEM READY – means that internal parameters are set correctly
REMOVE WHEN REQUIRED – means the unit is ready for use. As commented above if this is a
first time use, it is good practice to leave the unit in the DS for 1 hour to get some level of
battery charge.
When the unit is removed from the DS, system operation is automatically started in the SEARCH mode.
SYSTEM NOT
READY
WARMING UP
WAIT
WARMING UP
SYSTEM
READY
REMOVE WHEN
REQUIRED
WARMING UP
NOTE:
LEAVE THE UNIT IN THE DS WHEN NOT IN USE