- 3 -
Getting Started
1. Connect fibre optic ‘termination’ to the front of the Superactive LED Fiber
Optic Lightsource and tighten the bolt to hold the termination in position.
2. Place the Superactive LED Fiber Optic Lightsource on a flat solid floor or
mount securely on a wall.
3. Connect the round XLR connector (silver connector with grey cable) from
the Low Voltage transformer to the socket on the back of the unit.
4. Connect the standard mains plug to a mains outlet.
5. The Fiber Optics will now illuminate and will scroll through the many
colors.
6. Insert the 4 x 1.5v AA size batteries into the wireless controller (see the
next page).
7. Press any of the colored buttons to change the color of the Fiber Optics.
Modes of operation
Superactive mode is activated by using the 8 Button Wireless Controller to
operate the Fiber Optics.
Calming mode is activated when the 8 Button Wireless Controller has been left
dormant for 5 minutes. In this mode the Fiber Optics color sequences
automatically.
Please note: Only use the transformer supplied. Use of a different
transformer may result in damage to the product and void the warranty.
For warranty information please see separate warranty card supplied.
Installing Batteries
IMPORTANT: BATTERY INFORMATION
Please retain this information for future reference.
Batteries should be replaced by an adult.
1.
Turn the unit upside down to see the battery compartment.
2.
Apply pressure to the tab at either side.
3.
Remove the battery compartment drawer.
