ExPelec SENRUN EP-2001G Series, Руководство пользователя

Страница: 38 / 40

1. Please switch power off before start to changing batteries and modules.
2.Take out
6 pieces of screws and remove batteries plates from main panel board and take batteries out.
Install batteries 12VI5Ah into battery compartment.
3.Make sure the battery pack is properly inserted then closed the cover by tight up the screws.
To connected red terminal into battery
’s positive R1 red line terminal, black terminal into battery’s
negative B2 black line terminal, to gathered negative B1 and positive R2 to connect each and inserted.
4.Note: Make sure the pole with color. Refer to Instruction for Changing Battery Diagram 1. Do not make error
attached or otherwise causing damage or power is not working in perfect condition. To keep full batteries,
if you do not plan to use the unit for a long period of time.
Note: Diagram 1.
Red Black
Federal Communication Commission Interference Statement
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the
FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation.
This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with
the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference
will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception,
which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one
of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radioITV technician for help.
FCC Caution : To assure continued compliance, any changes or modifications not expressly approved by the party responsible
for compliance could void the user's authority to operate this equipment. (Example use only shielded interface cables when
connecting to computer or peripheral devices).
CAUTI O N :To reduce the risk of electric shock, do not remove the cover, No user serviceable
parts inside. Refer servicing to qualified personnel.
WARNI N G :To prevent fire or electric shock, do not expose this equipment to rain or moisture.
Explanation Of Graphical Symbols
The lightning flash with arrowhead symbol, within an equilateral triangle, is
intended to alert the user to the presence of uninsulated dangerous
voltage within the products enclosure that may be of sufficient magnitude
to constitute a risk of electric shock to humans.
The exclamation point, within an equilateral triangle, is intended to alert
the user to the presence of important operating and
maintenance(servicing) instructions in the literature accompanying the
appliance.
15
CAUTION
RISK OF ELECTRIC SHOCK
DO NOT OPEN
Warning
Instruction for changing battery