13
SOFTWARE INSTALLATION FOR DOS/WINDOWS 3.1
Automatic Installation
1)
Insert the GAME TRAVELER Card device driver diskette into your
floppy disk drive.
2)
Change the working directory to the floppy drive containing the device
driver diskette by typing “A:” or “B:”, and press ENTER.
3)
At the DOS prompt (A:\> or B:\>), type “INSTALL” followed by the
ENTER key.
4)
Press ENTER or click on the OK button when the opening screen
appears. A warning screen will be displayed to remind you this
installation program is for DOS/Windows 3.1 rather than for Window
95. Press “Y” or ENTER to continue, otherwise, press “N” to exit.
5)
If you select to continue the installation, a dialog box will then appear
for you to specify the directory and the I/O port to install the device
driver. Enter the directory you select and press the Tab key to forward
to next field to indicate the I/O port. After completing the selection,
press ENTER to continue. The rest of the installation will proceed
automatically.
6)
After completing, remember to reboot your system.
Note: Many notebook computers nowadays are designed to include the
GAME port. This will cause an I/O conflict between the GAME port and
the GAME TRAVELER Card I/O port under DOS environment. You may
use the BIOS of your notebook or other utilities provided by your
notebook to disable the GAME port or change the GAME port I/O
address rather than 201. Then set the I/O port of GAME TRAVELER
Card to 201-201 while performing the installation.
Manual Installation
You may also manually install the device driver by performing the following
steps.
1. Copy the files
E X P G A M E . E X E
from the GAME TRAVELER Card
device driver diskette to your hard disk.
2. Add the following lines to the BOTTOM of your CONFIG.SYS file:
D E V I C E
= driver:\path\
E X P G A M E . E X E / P 2 0 0
where drive:\path
specifies the directory containing the file
E X P G A M E
. E X E
.
