- 11 -
HARDWARE INSTALLATION (PC CARD)
Turn OFF your system before connecting the PCMCIA CD-ROM to your
computer.
1. Connect the PCMCIA interface card to the CD-ROM drive. Press firmly
until the connector is seated, and tighten the two screws on the cable
connector.
2. Place the drive in a horizontal position. The drive is designed to operate
only in a horizontal position. Operating the drive in any other position is
not recommended.
3. Make sure that the cable of the PCMCIA interface card is firmly
connected to the interface connector on the back panel of the CD-ROM
drive.
4. Locate the PCMCIA slot of
your computer or consult
your computer user’s
manual for its location.
5. Align
the
PCMCIA
interface card with the
arrow sign facing upward
and pointing toward the
computer’s slot. (Please note that the card is keyed to guide for proper
insertion.)
6. Slowly insert the PCMCIA interface card into the slot and press firmly
until the connector is seated.
7. Turn the system ON to install the PCMCIA CD-ROM device driver.
Please follow the Software Installation procedures on the next page.
CAUTION
You should connect the PCMCIA interface card to the CD-ROM drive
before
inserting the PCMCIA interface card into your computer.
DO NOT
connect/disconnect the PCMCIA interface card to/from the CD-ROM drive
when the system is ON.
