13.
Spool Holder
Parts Needed:
Printed spool bracket, 1x
M4x30 bolt, 2x
M4 nylock nut, 2x
M5x8 bolt, 3x
M5 T-nut, 3x
14.
Firmware
-Adjust the Z e-steps to 800 (from 400) by either the control interface, in firmware, or in your slicer start code
-Reverse the direction of the Z motor, by either reversing motor wires 1&3, in firmware, or in slicer start code
(use negative e-steps value of -800).
