27
MANUGENETOP5xxG - Version 1.05
© 2015-2019 EXOR International S.p.A. - Subject to change without notice
The equipment shall only be used in an area of not more than pollution degree 2, as defined in IEC/EN 60664-1.
- The equipment shall be installed in an enclosure that provides a degree of protection not less than IP 54 in
accordance with IEC/EN 60079-15.
- Transient protection shall be provided that is set at a level not exceeding 140 % of the peak rated voltage
value at the supply terminals to the equipment.
- Install the HMI device according to the accompanying installation instructions.
- Ground the HMI device according to the accompanying installation instructions.
- Only qualified personnel may install the HMI device or repair it.
- Ensure that the aeration holes are not covered.
- Care shall be taken not to allow layers of dust to form on the graphic panel in a way that might cause the
accumulation of static charges.
Keep the faceplate of the HMI device clean: the equipment must be clea
-
ned only with a soft cloth and neutral soap product. Do not use solvents.
- This device should not be used for purposes and methods other than indicated in this document and
in the documentation accompanying the product.
eTOP Series 500 Glass HMI products must be programmed with the software JMobile Studio. JMobile Stu-
dio is a software tool that must be properly installed on a computer running Microsoft Windows.
There are two options to transfer a JMobile application project to a HMI device:
Ethernet
Connect the HMI device to the computer with an Ethernet network connection. From
JMobile Studio choose the command Run/Download to target. You may have to
ensure that the proper firewall policy has been configured in the computer to allow
JMobile Studio to access the network.
USB or SD
Create an Update Package using JMobile Studio and copy it to a USB Flash drive or
to an SD memory card.
8 Special Instruction for Use
9 Getting Started
