25
MANUGENETOP3xx - Version 2.00
© 2018 EXOR International S.p.A. - Subject to change without notice
ENTER
shows the type and version of the communication driver stored in the unit (if any) and boot
FW version.
ENTER 2 s
returns to Operation Mode if a valid communication driver and a valid project are stored in
the unit (the key must be pressed for 2 seconds).
CLEAR 2 s
Call standard touchscreen calibration procedure
2 s
Update firmware
2 s
Erase Static RAM (Password and Recipe reset)
2 s
Shows memory menu
To change the panel IP address, Ethernet GMT and DST settings: touch the item you want to change.
12.1 Operation Mode/Page Mode
To recall the Configuration Mode, touch the screen in an area where no active touch areas have been
defined and hold for 2 seconds. The value of 2 seconds can be changed with Designer on disabled
requiring the use of a touch button programmed with the specific enter configuration mode macro.
Command Menu
select up
select down
select left
select right
ENTER
activate selection
CLEAR
return to Page Mode
System Menu
select up
select down
activate selection
activate selection
ENTER
return to Page Mode when EXT is selected
CLEAR
return to Page Mode
12 Configuration Mode
