2
S
ETTING
U
P AND
U
SING
Y
OUR
H
EAT
B
AND
S
YSTEM
Your HeatBand System is simple to set-up and use. Each HeatBand System comes supplied with a 3.7 volt,
lightweight miniature PowerPack and will normally be charged and ready to use when received. Moving
the switch vertically (to the ‘On’ position) will light the LED green, which indicates that power is available.
To operate your HeatBand System, simply insert the HeatBand plug into the miniature (charged)
PowerPack and then slip it into the pocket provided.
To charge your HeatBand PowerPack, connect it to the supplied charger unit and plug it into a standard
electrical outlet. Please ensure that the PowerPack is switched
on
when being charged. The charger unit
LED will light red until charging is complete, at which time the charger LED will change to green. The
HeatBand PowerPack can then be unplugged and used normally. It will take several hours to charge the
PowerPack fully, however a fast charge, offering several hours of heat, can be achieved after just one hour
of charging.
DO NOT LEAVE CHARGING BATTERIES UNATTENDED.
H
EAT
B
AND
S
YSTEM
S
PECIFICATIONS
Quality fleece lined inner
For Comfort
FabRoc™ Panel at rear section (self-regulating at approximately 115°F to relax tensed muscles and
increase blood flow)
For Soothing Warmth
over many hours of use
Neoprene exterior
For Flexibility
and
Durability
Velcro fastener For
Snug Fit
and
Maximum Flexibility
in all conditions
exo² Embroidery Branding
S
AFETY
F
EATURES
DO NOT
replace or interfere with the electrical components of your HeatBand, the PowerPack (batteries)
or charger unit.
The FabRoc™ heating element installed into your new HeatBand has been designed for safe and reliable
use. The power system has been tested to comply with US safety regulations and has been CE marked and
UL certified. Safety devices are included to ensure the unit is rendered safe, even under faulty conditions.
Please Note: The HeatBand System is not designed to be used under water.
