2
.
Placing the Heart Shaped Sensor on the Pajama
1.
To attach the Heart Rate Belt, pull the pajama inside out. Next, attach the belt.
There are Velcro ends on both sides. Simply attach the Velcro ends of the garment
to the corresponding Velcro end of the belt. They will hold each other.
Make sure to tuck each side of the belt into the cotton flaps to avoid baby skin
irritation. The two buttons on the Heart Rate Belt should pop up outside of garment
through the holes. Now turn the pajama back from the inside out position.
2. The Heart Shaped Sensor can then be snapped on to the exposed snap buttons
on the front side of the pajama. The little infrared skin thermometer on the bottom of
the Heart Shaped Sensor should be pointed at the baby's skin through the top hole
on the pajama.
3. To turn on the Heart Shaped Sensor, press the button on the sensor until the red
LED flashes twice. This light indicates that the sensor has been activated. To turn
off the Heart Shaped Sensor, hold down this button for 7 seconds until the bright
red LED flashes once. This indicates that Heart Shaped Sensor is turned off.
Quick update on data: Press the Heart Shaped Sensor button for 4 seconds continuously.
That action will update the latest temperature and heart rate data immediately.
7
www.exmovere.com
Getting Started