Figure 3
1.
Throttle control lever
3.
Clamp
2.
Throttle cable — Located
on bottom side of clamp.
Install the PTO Engagement
Linkage
1. Loosen the jam nut and remove the turnbuckle from
the lower linkage (Figure 4).
2. Screw the turnbuckle onto both the upper and the
lower linkages simultaneously. Note that threads on
upper linkage are left hand.
Note:
The handles have the drive lever linkage on
the inside of the blade engagement lever tab and the
hairpin on the outside.
Figure 4
1.
Lower PTO engagement linkage
2.
Jam nut
3.
Turnbuckle
4.
Upper PTO engagement linkage
3. With the PTO engaged, adjust the linkage length
by loosening the locknut on the turnbuckle and
adjusting the turnbuckle so that the bolt on the
bellcrank and the indicator arm align with each
other within 1/16 inch (1.6 mm) (Figure 5). Tighten
locknut against turnbuckle.
Figure 5
1.
Engine deck
3.
Align bolt to indicator
within 1/16 inch (1.6 mm)
2.
Indicator
4.
Turnbuckle
Installing the Speed Control Rod
1. Locate the speed control rod assembly with a yoke
at one end.
3
