Operation
•
Rear Discharge Units:
Torque the 3/8 nyloc nut to 30-35 ft-lb (41-47
N-m) (see Figure 19 ).
g035123
Figure 19
1.
3/8 inch nyloc-torque to
30-35 ft-lb (41-47 N-m)
3.
Wheel spacer
2.
Anti-scalp rollers
4.
3/8-16 X 7 3/8 inch bolt
Note:
The foot operated deck lift assist lever can be
used to momentarily lift the deck to clear objects. Be
sure that PTO is disengaged.
Adjusting the Side Bumpers
(Rear Discharge Units Only)
Mount the side bumpers in the top holes when
operating in height of cuts higher than 2 1/2 inches
(64 mm) and in the center holes when operating in
height of cuts lower than 2 1/2 inches (64 mm).
Note:
When bumpers become worn, switch the
bumpers to the opposite sides of the mower, flipping
them over. This allows the bumpers to be used longer
before replacing them.
1.
Stop the machine and move the motion control
levers outward to the neutral locked position.
2.
Disengage the PTO.
3.
Engage the park brake.
4.
Stop the engine, remove the key and wait for all
moving parts to stop.
5.
Position the transport lock in the latching
position.
6.
Remove the bolts and nuts from each bumper.
g035120
Figure 20
1.
Bolt
3.
Nut
2.
Bumper
7.
Move each bumper to the desired position and
secure them with the bolts and nuts.
Note:
Only use the top or center sets of holes to
adjust the bumpers. The bottom holes are used
when switching sides, at which time they become
the top holes on the other side of the mower.
After Operation
General Safety
•
Park machine on level ground, disengage drives,
set parking brake, stop engine, and remove key.
Wait for all moving parts to stop before leaving
the operator’s position. Allow the machine to
cool before servicing, adjusting, fueling, cleaning,
or storing.
•
Clean grass, leaves, excessive grease or oil, and
other debris from the mower deck, muffler, drives,
grass catcher, and engine area to help prevent
fires.
•
Close the fuel shut-off valve before storing or
transporting the machine.
Transporting
Transporting the Machine
Use a heavy-duty trailer or truck to transport the
machine. Ensure that the trailer or truck has all
necessary lighting and marking as required by law.
Thoroughly read all of the safety instructions.
31
Содержание Radius E Series
