Exmark QUEST 346, Руководство оператора

Страница: 14 / 72

Operation
Product Overview
g333776
Figure 3
1. Front caster wheel 7. Engine
2. Deck height adjustment
foot pedal 8. Seat
3. Anti-scalp roller 9. Fuel tank
4. Discharge deflector 10. Motion control levers
5. Rear drive wheel 11. Footrest
6. Control panel
Operation
Note:
Determine the left and right sides of the
machine from the normal operating position.
Controls
Become familiar with all the controls before starting
the engine and operating the machine.
Ignition Switch
Located on control panel.
The ignition switch is used to start and stop the
engine. The switch has three positions “OFF”,
“RUN” and “START” (Figure 4). Insert key into
switch and rotate clockwise to the “ON” position.
Rotate clockwise to the next position to engage the
starter (key must be held against spring pressure in
this position).
g333787
Figure 4
1. Ignition switch
2. Off
3. Run
4. Start
5. Blade control switch (Power Take-Off)
6. Choke control
7. Hour meter (if equipped)
8. Throttle lever
Note:
Brake must be engaged and PTO switch
“OFF” to start engine. (It is not necessary for the
operator to be in the seat to start the engine.)
Turning the key to the “OFF” position will stop the
engine; however, always remove the key when leaving
14