Exmark Quest 126-7510, Руководство пользователя

Страница: 19 / 24

Removing the Bagger
CAUTION
Failing to remove the front bagger weights
from lever steer models and operating the
machine without the bagger attachment may
cause an unstable condition which could
result in a loss of control.
• Always remove the front weights (where
required) when removing the bagger
attachment.
• Never operate the machine without the
bagger attachment and the front weights
(where required) still installed.
The bagger can be removed by repeating the Setup
sections from all installed bagger related kits in
reverse order. If weights are installed, always remove
the front bagger weights when removing the bagger
attachments.
Note:
It is only necessary to remove the cutoff baffle
when installing a mulching kit.
Using the Draw Bar
The attachment mount has a draw bar feature that
can be used for towing.
•
Read and understand all the operating instructions
of the machine.
•
When turning, slow down and observe the
clearance.
•
Make wide turns and keep towed equipment clear
of the towing vehicle.
•
The maximum draw bar pull is 36 kg (80 lb).
•
Excessive draw bar pull may cause hydrostatic
transmission failure.
g028309
Figure 33
1. Attachment mount with draw bar
Transporting
Transporting the Machine
Use a heavy-duty trailer or truck to transport the
machine. Ensure that the trailer or truck has all
necessary brakes, lighting, and marking as required
by law. Please carefully read all the safety instructions.
Knowing this information could help you, your family,
pets, or bystanders avoid injury.
WARNING
Driving on the street or roadway without turn
signals, lights, reflective markings, or a slow
moving vehicle emblem is dangerous and can
lead to accidents causing personal injury.
Do not drive machine on a public street or
roadway.
To transport the machine:
1. If using a trailer, connect it to the towing vehicle
and connect the safety chains.
2. If applicable, connect the trailer brakes.
3. Load the machine onto the trailer or truck.
4. Stop the engine, remove the key, set the brake,
and close the fuel valve.
5. Tie down the machine near the front caster
wheels and the rear bumper (
Figure 34 ).
g027708
Figure 34
Loading the Machine
Do Not transport the machine with the hopper
full. Empty the hopper before attempting to load
machine on trailer or truck. This will reduce the
chance of rearward tip up.
Use extreme caution when loading or unloading
machines onto a trailer or a truck. Use a full-width
ramp that is wider than the machine for this procedure.
Back up ramps and drive forward down ramps (
Figure
35 ).
19