Page 4 of 13
109-4232 Rev. A
Safety
Safety Alert Symbol
This SAFETY ALERT SYMBOL
is used
both in this instruction sheet and on the machine
to identify important safety messages which must
be followed to avoid accidents. This symbol
means:
ATTENTION! BECOME ALERT!
YOUR SAFETY IS INVOLVED!
The safety alert symbol appears above information
which alerts you to unsafe actions or situations and
will be followed by the word
DANGER
,
WARNING
,
or
CAUTION.
DANGER
: White lettering / Red background.
Indicates an imminently hazardous situation which,
if not avoided,
WILL
result in death or serious injury.
WARNING
: Black lettering / Orange background.
Indicates a potentially hazardous situation which, if
not avoided,
COULD
result in death or serious
injury.
CAUTION
: Black lettering / Yellow background.
Indicates a potentially hazardous situation which, if
not avoided,
MAY
result in minor or moderate injury.
Install Hood Assembly and Bags
Note: Reference the previous assembly diagrams for
the Item numbers called out in the installation
instructions.
All Lazer Z XP, Lazer Z XS units and Lazer Z
Units with SN 510,000 and Higher:
1. Temporarily remove the ROPS to allow for
installation of the Ultra Vac. Retain the hardware for
reuse.
For Lazer Z units SN 510,000 and Higher:
2. When installing the Ultra Vac onto a liquid cooled
Lazer Z, the rear bumper plate must be removed.
Remove rear bumper plate. Reattach the lower side
bumper bars to the vertical “HOT” engine guard
shield using two of the original screws, washers and
whizlock nuts removed from the bumper plate.
3. Remove the lower two screws holding the clutch
guard plate (“HOT” engine guard on liquid cooled
units) to the rear frame of the Lazer Z unit.
4. Install the mount weldment (Item 9) loosely to the
rear of the machine using the two bolts and nuts
removed in Step 1
For Lazer Z XP Lazer Z XS units:
5. Install mount weldment (Item 9) loosely to the
rear bumper using the two holes provided.
Secure using (2) 3/8-16 x 1.00 screws (Item 23),
(2) 3/8 spring disk washers (Item 25) and (2) 3/8-
16 whizlock nuts (Item 24).
All Lazer Z XP, Lazer Z XS units and Lazer Z
Units with SN 510,000 and Higher:
6. Install the frame brackets (Item 16) and spacers
(Item 17) loosely to the mount weldment (Item 9)
as shown. Secure using (2) 3/8-16 x 1.00 screws
(Item 23), (2) 3/8 spring disk washers (Item 25)
and (2) 3/8-16 whizlock nuts (Item 24). Make
sure that the raised portion of the spring disk
washer faces the head of the screw (See
Figure 2).
FIGURE 2
RELEASED Version ©Toro 2006-2007
