Exmark 126-3925 Скачать руководство пользователя страница 4

13.

Loosen the cable support nut.

14.

Pull the cable jacket down (toward the machine) until
there is no slack in the cable.

Figure 8

15.

Tighten the nut on the cable support.

16.

Zip tie the cable to the brace to the left of the fuel tank
and down the handle as shown in Figure 1.

Note:

Make sure the self-propel cable does not kink

at the transmission.

Note:

Make sure the BBC (Blade Brake Clutch) arm

does not interfere with the cable routing.

17.

Reconnect the spark plug wire.

18.

Using the Adjustments section in the Operator’s
manual, check and adjust the self-propel drive and
BBC.

4

 

Содержание 126-3925

Страница 1: ...ls known to the State of California to cause cancer birth defects or reproductive harm Loose Parts Use the chart below to verify that all parts have been shipped Item Part No Description Qty 1 126 1664 Cable 1 2 614249 Tie Wire 3 3 3290 55 Rivet 2 Figure 1 2014 Exmark Mfg Co Inc Industrial Park Box 808 Beatrice NE 68310 www Exmark com Original Instructions EN Printed in the USA All Rights Reserved...

Страница 2: ...d Note emphasizes general information worthy of special attention WARNING If you leave the wire on the spark plug someone could accidentally start the engine Accidental starting of the engine could seriously injure you or other bystanders Disconnect the wire from the spark plug before you do any maintenance Set the wire aside so that it does not accidentally contact the spark plug Note Determine t...

Страница 3: ...n 2 Drill hole 3 Place the serial tag on the left side of the frame in the location shown in Figure 7 and mark the mounting hole locations Remove the plate and drill two 143 inch 3 63 mm diameter holes Install the serial tag using the two rivets from the kit 4 Insert the spring end of the new cable into the hole drilled in step 2 5 Tip the mower onto its right side 6 Reattach the cable spring end ...

Страница 4: ...ble to the brace to the left of the fuel tank and down the handle as shown in Figure 1 Note Make sure the self propel cable does not kink at the transmission Note Make sure the BBC Blade Brake Clutch arm does not interfere with the cable routing 17 Reconnect the spark plug wire 18 Using the Adjustments section in the Operator s manual check and adjust the self propel drive and BBC 4 ...

Отзывы: