Setup
Ream out the right hole to 11/32 inch
diameter.
g012622
Figure 12
1.
Drill
3.
Mounting bracket
2.
5/16-18 x 5/8 inch
carriage bolt
4.
5/16 inch nyloc nut
E.
Align the two holes in the mounting
bracket with the panel of the unit. Install
5/16-18 x 5/8 inch carriage bolt and 5/16
inch nyloc nut in the hole on the right side.
F.
Insert the handle assembly into the
mounting bracket as shown in Figure 13.
g012623
Figure 13
1.
Handle assembly
3.
Clevis pin
2.
Mounting bracket
4.
Hairpin
G.
Insert the clevis pin through the handle
assembly hole, into the left hole of the
mounting bracket, and through the panel
of the unit. Secure the handle assembly
with hairpin as shown in Figure 13.
H.
For Vantage 48 and 52 units:
Remove
the nut from the front panel guard, install
the loom clip, and replace nut as shown
in Figure 14.
g012690
Figure 14
Vantage 48 and 52
1.
Front panel guard
3.
Nut
2.
Loom clip
For Vantage 60 units:
Route the cable
under the RH frame rail, over the front
RH bellcrank and along the top rear of
the engine.
12
Содержание 116-8430
Страница 22: ...Notes 22...
Страница 23: ...Service Record Date Description of Work Done Service Done By 23...