EXIT Toys 8633960640, Руководство пользователя

Страница: 48 / 98

www.jilong.com SFP7-16-GB
Diagnosis of Problems and Solutions
Problems Checking Solutions
T h e m o t o r c a n n o t b e
started normally
Power plug not properly
inserted
L e a k a g e p r o t e c t i o n
disconnected
M o t o r o v e r h e a t e d o r
overloaded
Causes motor to stop
Make sure the power cord is inserted
into the 3-core grounded metal
receptacle.
Reset circuit breaker. If the problem
persists, the power system may be
defective. Power off immediately and
confer with an expert.
Allow the motor to cool naturally and
start it again.
Filter
Unable to rinse the pool
No sand in the body
Location error of the control
valve
Excessive dirt in water
Filter barrel blocked
Sand filling Refer to sand filling
instructions
The control valve rotates to the filter
position
to prolong the running time
Clean the filter barrel
The filter is unable to
discharge water or the water
flow rate is too slow
There is blockage at the
inlet
There is an air leakage at
the gap of the inlet
Excessive dirt in water
Filter medium is blocked by
impurities
The pool is connected with
a cleaning device
Check and clear away the blockage in
the water pipes
Tighten the nozzle nuts and check the
damaged point of the nozzle and water
height
Clean the filter screen
Backwash
Disassemble the cleaning device
connected to the pool
Filter fails to run Water level is too low
Filter screen is blocked
Air leakage from the inlet
pipe
Motor or blade is blocked
Inject water to adjust water level
Clean the filter screen in the pool
Tighten the nozzle and check the
damaged point
Replace the fittings
Water leakage on the control
valve or upper cover
The seal ring of the body is
lost or too dirty
The control valve retainer
i s n o t t i g h t l y s e c u r e d
ordamaged
Remove the upper cover of the control
valve and sleeve the seal ring of the
body
Clean the seal ring of the body with a
water pipe
Tighten the screw with a screwdriver
Replace the fittings
The manometer fails to run T h e i n n e r w a l l o f t h e
manometer is blocked
The manometer is damaged
Remove the manometer from the
control valve and clear away the
impurities on the inner wall
Replace the fittings
Sand enters the pool The sand particles are too
fine
Use 20# quartz sand only
Particle size of the sand is 0.45-0.85mm
Or replace the sand