10
MODEL EF34
Optional Accessories
A- Concrete Mounting Hardware
Concrete mounting hardware MUST be used when installing directly to concrete without the use
of a juntion box.
Installation step 1-3 should be completed prior to installation of the ceiling mount.
a.
Place the ceiling mount flush onto the
ceiling in the location where the fan will
be mounted.
b.
Using the mount as a guide, mark the 4
bolt locations onto the ceiling where the
expansion anchors will be installed.
Expansion
anchors
Qty: 4
c. Remove the ceiling mount from the ceiling and check that the 4 locations marked are clear and
free from obstacles.
d. Using a 10 mm drill bit, drill the 4 bolt locations at least 40 mm deep into the concrete ceiling. (Be
sure to clean any remaining dust from the hole when finished).
Figure A.
e. Run the supply wires through the center of the
ceiling mount and secure the mount to the ceiling
using the included 4 expansion anchors.
f. [Refer to step 5. Electrical Connections]
g. Secure the fan safety cable from the motor to the
support hook by sliding open loop of the safety cable
over the hook and sliding the loop collar until its
tight around the saft of the hook as seen in figure A
h. [return to Installation Step 6. Munting the motor]
